01
You are buying a home in the North End and the inspection report flags older plumbing.
What we do: We run a full leak detection scan before closing, focusing on supply lines, crawl space plumbing, and any area with visible staining. Thermal imaging and moisture metering cover the whole accessible system in about 90 minutes.
→ You get a written report with photos and moisture percentages you can use to negotiate repairs or walk away with real information instead of a guess.
02
A pipe burst during a January freeze and you have already had it repaired.
What we do: We verify the repair actually stopped the loss, then check the surrounding cavity for residual moisture. If humidity is still elevated, we recommend drying or air sampling before you close the wall back up.
→ You know whether the cavity is dry enough to rebuild, and you have documentation if mold shows up later and you need to file a claim.
03
Your tenant in a Boise Bench rental reports a musty smell in the bathroom.
What we do: We inspect the bathroom, the adjacent wall cavity, and the floor below with thermal imaging and a borescope. If the source is a slow drain leak, we document it and hand the landlord a repair scope.
→ The landlord gets a clear repair target and the tenant gets a documented answer, which usually resolves the dispute before it escalates.
04
Spring snowmelt has left a damp patch on your basement floor in Depot Bench.
What we do: We check the foundation wall, floor slab, and any interior drain with moisture meters and a hygrometer. We also inspect the exterior grade and downspout discharge to identify where the water is entering.
→ You get a clear answer on whether the fix is waterproofing, drainage, or a plumbing repair, plus a moisture baseline to compare against after the work is done.